|
楼主 |
发表于 2020-2-11 09:46:03
|
显示全部楼层
白色横线这头rx-tx-gnd三个 波特率设置115200 显示正常 但输入tpl 中断进程无效
U-Boot 1.1.4 (Apr 12 2013 - 19:34:20)
AP93 (ar7240) U-boot
DRAM:
sri
#### TAP VALUE 1 = 8, 2 = 8
32 MB
id read 0x100000ff
flash size 4194304, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7014
eth0: 00:03:7f:09:0b:ad
eth0 up
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7214
eth1: 00:03:7f:09:0b:ad
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth1 up
eth0, eth1
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... Error: Bad gzipped data
GUNZIP ERROR - must RESET board to recover
|
|