|
|
楼主 |
发表于 2019-1-15 20:42:52
|
显示全部楼层
本帖最后由 天涯浪人 于 2019-1-15 20:52 编辑
由于网上没找到有适用的配置方法，用平时通用的192.168.0.1,192.168.1.1去偿试，结果都没有反映，刚好手上有USB转串口TTL的板子，用线连接上电脑，用XP的终端连接上AP，结果从开机时传回的开机信息发现连接设置的IP，果断进行web登录，发现可以进行设置了，这个系列的AP可以设置专门的管理IP，也可以通过上一组设备分配给它的IP来进行web管理。
引导过程：
APBoot 1.5.3.21 (build 47715)
Built: 2014-12-17 at 19:19:51
Model: AP-103
CPU: AR9344 revision: 1.2
Clock: 560 MHz, DDR rate: 429 MHz, Bus clock: 214 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 32 MB
Power: DC
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0033 00002 01 10000004 00000000 00000000 00000000
Net: eth0
Radio: ar9590#0, ar9344#1
Hit <Enter> to stop autoboot: 0
Booting OS partition 0
Checking image @ 0xbf100000 (bank 1)
Image is signed; verifying checksum... passed
Signer Cert OK
Policy Cert OK
RSA signature verified.
ELF file is 32 bit
Loading .text @ 0x81c00000 (8270280 bytes)
Loading .data @ 0x823e31d0 (32 bytes)
Clearing .bss @ 0x823e31f0 (16 bytes)
## Starting application at 0x81c00000 ...
Uncompressing...............................................................................
Aruba Networks
ArubaOS Version 6.4.0.3-4.1.0.1 (build 46511 / label #46511)
Built by p4build@cartman on 2014-10-14 at 04:52:00 PDT (gcc version 4.3.3)
CPU Rev: 2122
934x CPU
flash_size passed from bootloader = 32
arg 1: mem=128M
Flash variant: 32M
ath_sys_frequency: cpu apb ddr apb cpu 560 ddr 430 ahb 215
Cache parity protection disabled
ath_timer_init: plat time init done
Using 280.000 MHz high precision timer. cycles_per_jiffy=560000
Memory: 118556k/131072k available (1697k kernel code, 12380k reserved, 698k data
, 7380k init, 0k highmem)
available.
detected lzma initramfs
initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=33048576
LZMA initramfs by Ming-Ching Tiew <mctiew@yahoo.com>
PCI init:ath_pcibios_init
Returning IRQ 64
ATH GPIOC major 0
wdt: registered with refresh
Enabling Watchdog
Talisker RSSI LED initialization
Concatenating MTD devices:
(0): "bank1"
(1): "bank2"
into device "flash"
Creating 1 MTD partitions on "flash":
0x00000000-0x02000000 : "flash"
i2c /dev entries driver
i2c-talisker: using default base 0x18040000
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT
Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT
Starting Kernel DES KAT ...Completed Kernel DES KAT
Starting Kernel AES KAT ...Completed Kernel AES KAT
Starting Kernel AESGCM KAT ...Completed Kernel AESGCM KAT
Domain Name: instant.arubanetworks.com
No panic info available
Check backup ENV.
ATHR_GMAC: RX TASKLET - Pkts per Intr:16
ATHR_GMAC: Mac address for unit 0:80abdbc0
ATHR_GMAC: 04:bd:88:c8:22:48
ATHR_GMAC: Mac capability flags : 42201
ATHR_GMAC: RX TASKLET - Pkts per Intr:16
ATHR_GMAC: Mac address for unit 1:80abdbc0
ATHR_GMAC: 04:bd:88:c8:22:49
mac:1 Registering S27....
ATHR_GMAC: Mac capability flags : 42A00
WASP ----> S17 PHY *
athrs17_reg_init:done
Phy setup Complete
Cfg len is 2.5k
Loading configuration file of length 2.5k...
wifi uplink not present...
extened ssid config detected...
Terminal access enabled...
Valid SSID detected...
do ethtool autoneg on for eth0
Cannot get current device settings: No such device
not setting autoneg
WASP ----> S17 PHY *
athrs17_reg_init:done
Setting PHY...
Phy setup Complete
[az] 802.3az init done..
ADDRCONF(NETDEV_UP): bond0: link is not ready
Enet:0 port0 up
athr_gmac_poll_link: unit 0 link change to up
ATH_MAC_TIMER: enet unit:0 is up...
Mii 100Mbps full duplex
ATH_MAC_TIMER: Done cfg2 0x7135 ifctl 0x10000 miictrl
ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready
Mesh is DISABLED on this device.
drvlog_mod: module license 'Proprietary' taints kernel.
AP xml model 76, num_radios 2 (jiffies 15723)
init_asap_mod: installation:0
radio 0: band 1 ant 0 max_ssid 16
radio 1: band 0 ant 0 max_ssid 16
election init: rand=1c HZ=500
IAP client match init
asap_proc_win_mac_oui_tab_init: init.
notify asap_mod 3g no present...
Starting watchdog process...
Getting an IP address...
Dec 31 16:00:31 udhcpc[1205]: udhcpc (v0.9.9-pre) started
Dec 31 16:00:31 udhcpc[1205]: send_discover: pkt num 0, secs 0
Dec 31 16:00:31 udhcpc[1205]: Sending discover...
Dec 31 16:00:31 udhcpc[1205]: send_selecting: pkt num 0, secs 0
Dec 31 16:00:31 udhcpc[1205]: Sending select for 192.168.1.147...
Dec 31 16:00:32 udhcpc[1205]: Lease of 192.168.1.147 obtained, lease time 86400
Dec 31 16:00:32 udhcpc[1205]: DHCP OPT 43 deleted airwave config
192.168.1.147 255.255.255.0 192.168.1.1
Compressing all files in the /etc/httpd directory...
ip_time_handler: Got ip and packets on bond0 Started master election 2-0, rand 17 Done.
Starting Webserver
bind: Transport endpoint is not connected
bind: Transport endpoint is not connected
bind: Transport endpoint is not connected
Launching NTP Client on pool.ntp.org
ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D)
ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved
ath_rate_atheros: Aruba Networks Rate Control Algorithmath_dfs: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reservedath_spectrum: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reservedath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved
ath_pci: 0.9.4.5 (Atheros/multi-bss)
Restoring Cal data from Flash
Reading from Addr: 0xbffe5000
ath_attach: scn 85c40280 sc 85d00000 ah 85800000
wifi1: AP type AP-103, radio 1, max_bssids 16
wifi1: Atheros 9340: mem=0xb8100000, irq=2
shutting down watchdog process (nanny will restart it)...
Completed SW FIPS KAT test
<<<<< Welcome to the Access Point >>>>>
User: process `snmpd_sap' is using obsolete setsockopt SO_BSDCOMPAT
i am master now
(05:49:41) !!! Init ---> Master
asap_send_elected_master: sent successfully
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看，没有账号？立即注册
x
|
IP归属地
雷达卡
发表于 2019-1-15 20:42:18
提帖卡
置顶卡
锁帖卡
解锁卡
显目卡
千斤顶
