|
|
发表于 2022-12-8 16:51:11
|
显示全部楼层
大神，我知道你是高手，我现在有个cm201-2 mv300，nand的盒子，现在没有fastboot，httool刷不进去，强刷也不行，不确定是fastboot不对还是nand坏了，开机只能进usb，我试过用ubuntu的u盘进去过系统，显示有16个分区，只显示有4mib，然后我把各种强刷包放到u盘里去试，现在ttl开机信息如下，请大神看看是那个问题，谢谢了 ！
Enter usb bootstrap by flash
USB: Recv CC:4
Usb disk(1):
Decrypt auxiliary code ...OK
lsadc voltage min: 000002FF, max: 00000303, aver: 00000300, index: 00000001
Enter boot auxiliary code
Auxiliary code - v1.00
DDR code - V1.1.2 20160205
Build: Jul 27 2018 - 00:49:01
Reg Version: v1.5.1`
Reg Time: 2018/05/23 16:01:07
Reg Name: hi3798mv3dms1_hi3798mv300_DDR3-1866_1GB_16bitx2_2layers_cm.reg
dms board
Boot auxiliary code success
Bootrom success
System startup
Relocate Boot
Jump to C code
Compressed-boot v1.0.0
Uncompress..............................Ok
System startup
Relocate Boot
Jump to C code
Fastboot 3.3.0 (jenkins@ubuntu) (Apr 17 2019 - 23:44:25)
Fastboot: Version 3.3.0
Build Date: Apr 17 2019, 23:45:57
CPU: Hi3798Mv300
Boot Media: NAND
DDR Size: 1GB
Found flash memory controller hifmc100.
Nand ID: 0x2C 0x64 0x44 0x4B 0xA9 0x00 0x00 0x00
Nand: Micron MT29F64G08CBABBWP Read-Retry ONFI DDR 2.3
Nand(HW-Auto): Block:2MB Page:8KB OOB:744B ECC:40bit/1k Chip:4MB*1
MMC/SD controller initialization.
No MMC device found !
(Re)start USB...
USB0: Register 1212 NbrPorts 2
USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
USB0: Register 2000140 NbrPorts 2
USB XHCI 1.00
scanning bus 0 for devices... 1 USB Device(s) found
scanning usb for storage devices... EHCI timed out on TD - token=0x80008c80
1 Storage Device(s) found
reading bootargs.bin
bootargs.bin on device:usb:0:1 FOUND!
reading bootargs.bin from 0
...Net: up, down, gmac0
Boot Env on MFTL
Env Offset: 0x00400000
Env Size: 0x00010000
Env Range: 0x00010000
start download process.
SDK Version: HiSTBAndroidV600R003C01SPC031_patch4
[MU]Micron LLD for U-Boot - Built: Apr 17 2019, 23:45:54
[MU]mt_nand_init: NAND Device 0 Failed Reset!
[MU]mod_lld_init: NAND Hardware Initialization Failed!
[MU]uboot_mtlld_init: LLD Initialization Failed!
[MU]=============================================================
[MU]Micron FTL for U-Boot - Built: Apr 17 2019@23:45:54
[MU]=============================================================
[MU]module_sbl_init: Invalid SBL Number of Chips Input
(Re)start USB...
USB0: Register 1212 NbrPorts 2
USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
USB0: Register 2000140 NbrPorts 2
USB XHCI 1.00
scanning bus 0 for devices... 1 USB Device(s) found
scanning usb for storage devices... EHCI timed out on TD - token=0x80008c80
1 Storage Device(s) found
reading recovery.img
recovery.img on device:usb:0:1 FOUND!
reading recovery.img from 0
...........................................................................................................................................................................................................................................................
Found Initrd at 0x04000000 (Size 1160535 Bytes), align at 2048 Bytes
## Booting kernel from Legacy Image at 01000800 ...
Image Name: Linux-3.18.24_hi3798mv310
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3981468 Bytes = 3.8 MiB
Load Address: 02000000
Entry Point: 02000000
Loading Kernel Image from 0x16779328 to 0x33554432 ... OK
OK
ATAGS [0x00000100 - 0x00000414], 788Bytes
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Booting Linux on physical CPU 0x0
Linux version 3.18.24_hi3798mv3x (jenkins@ubuntu) (gcc version 4.9.4 (gcc-linaro-4.9-2017.01 + glibc-2.27 Build by czyong Thu Mar 29 22:12:18 CST 2018) ) #1 SMP Mon Mar 25 14:25:06 CST 2019
CPU: ARMv7 Processor [410fd034] revision 4 (ARMv7), cr=10c5383d
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
initmrd: found no initmrd.
tag-emmc: emmc is not scaned!
Machine model: Hisilicon
cma: Reserved 44 MiB at 0x3cc00000
cma: Reserved 4 MiB at 0x3fc00000
Memory policy: Data cache writealloc
PERCPU: Embedded 10 pages/cpu @debc2000 s10048 r8192 d22720 u40960
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 261144
Kernel command line: console=ttyAMA0,115200 blkdevparts=mftl:4M(reserved),4M(bootargs),12M(recovery),4M(deviceinfo),8M(baseparam),8M(pqparam),20M(logo),20M(logobak),40M(fastplay),40M(fastplaybak),40M(kernel),20M(misc),40M(trustedcore),800M(backup),800M(system),500M(cache),50M(private),8M(securestore),-(userdata) initrd=0x4000000,0x11B557 mem=1G mmz=ddr,0,0,44M
log_buf_len individual max cpu contribution: 4096 bytes
log_buf_len total cpu_extra contributions: 12288 bytes
log_buf_len min size: 16384 bytes
log_buf_len: 32768 bytes
early log buf free: 14156(86%)
PID hash table entries: 2048 (order: 1, 8192 bytes)
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 977708K/1048576K available (6121K kernel code, 478K rwdata, 2232K rodata, 1529K init, 810K bss, 70868K reserved, 486896K highmem)
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xffc00000 - 0xfff00000 (3072 kB)
vmalloc : 0xdf800000 - 0xff000000 ( 504 MB)
lowmem : 0xc0000000 - 0xdf400000 ( 500 MB)
pkmap : 0xbfe00000 - 0xc0000000 ( 2 MB)
modules : 0xbf000000 - 0xbfe00000 ( 14 MB)
.text : 0xc0008000 - 0xc0830974 (8355 kB)
.init : 0xc0831000 - 0xc09af740 (1530 kB)
.data : 0xc09b0000 - 0xc0a27a84 ( 479 kB)
.bss : 0xc0a27a84 - 0xc0af22d4 ( 811 kB)
SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=4, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:352
sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956969942ns
Calibrating delay loop... 2383.87 BogoMIPS (lpj=1191936)
pid_max: default: 32768 minimum: 301
Security Framework initialized
SELinux: Initializing.
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
CPU: Testing write buffer coherency: ok
ftrace: allocating 23943 entries in 71 pages
CPU0: thread -1, cpu 0, socket 0, mpidr 80000000
Setting up static identity map for 0x57b8f8 - 0x57b950
CPU: hi3798mv300
CPU1: thread -1, cpu 1, socket 0, mpidr 80000001
CPU2: thread -1, cpu 2, socket 0, mpidr 80000002
CPU3: thread -1, cpu 3, socket 0, mpidr 80000003
Brought up 4 CPUs
SMP: Total of 4 processors activated (9572.35 BogoMIPS).
CPU: All CPU(s) started in SVC mode.
VFP support v0.3: implementor 41 architecture 3 part 40 variant 3 rev 4
regulator-dummy: no parameters
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
Serial: AMBA PL011 UART driver
f8b00000.uart: ttyAMA0 at MMIO 0xf8b00000 (irq = 81, base_baud = 0) is a PL011 rev2
console [ttyAMA0] enabled
f8b02000.uart: ttyAMA1 at MMIO 0xf8b02000 (irq = 83, base_baud = 0) is a PL011 rev2
f8b03000.uart: ttyAMA2 at MMIO 0xf8b03000 (irq = 84, base_baud = 0) is a PL011 rev2
pl061_gpio gpio0: PL061 GPIO chip @0xf8b20000 registered
pl061_gpio gpio1: PL061 GPIO chip @0xf8b21000 registered
pl061_gpio gpio2: PL061 GPIO chip @0xf8b22000 registered
pl061_gpio gpio3: PL061 GPIO chip @0xf8b23000 registered
pl061_gpio gpio4: PL061 GPIO chip @0xf8b24000 registered
pl061_gpio gpio5: PL061 GPIO chip @0xf8004000 registered
pl061_gpio gpio6: PL061 GPIO chip @0xf8b26000 registered
pl061_gpio gpio7: PL061 GPIO chip @0xf8b27000 registered
pl061_gpio gpio8: PL061 GPIO chip @0xf8b28000 registered
pl061_gpio gpio9: PL061 GPIO chip @0xf8b29000 registered
SCSI subsystem initialized
ssp-pl022 f8b1a000.spi: ARM PL022 driver, device ID: 0x00041022
ssp-pl022 f8b1a000.spi: mapped registers from 0xf8b1a000 to f9b1a000
spi_master spi0: will run message pump with realtime priority
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
hisi_iommu_ptable_addr:phy 0x1d800000 size:0x400000
hisi_iommu_err_rdaddr :phy 0x1dc15200 size:0x200
hisi_iommu_err_wraddr :phy 0x1dc15400 size:0x200
in hisi_iommu_domain_init start
in hisi_iommu_domain_init end
Switched to clocksource clk24M
NET: Registered protocol family 2
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP: reno registered
UDP hash table entries: 256 (order: 1, 8192 bytes)
UDP-Lite hash table entries: 256 (order: 1, 8192 bytes)
NET: Registered protocol family 1
Trying to unpack rootfs image as initramfs...
Freeing initrd memory: 1136K (c4000000 - c411c000)
futex hash table entries: 1024 (order: 4, 65536 bytes)
audit: initializing netlink subsys (disabled)
audit: type=2000 audit(0.287:1): initialized
ntfs: driver 2.1.31 [Flags: R/O].
msgmni has been set to 960
bounce: pool size: 64 pages
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
io scheduler noop registered
io scheduler deadline registered (default)
io scheduler cfq registered
brd: module loaded
hifmc100: registerd new interface driver hifmc100.
[MU]Resource: Device for DMA Mapping Located
[MU]Resource: io_base physical = 0xF9950000, Size 256
[MU]Resource: buffer physical = 0xFE200000, Size 8566
hifmc100: Found flash memory controller hifmc100.
random: nonblocking pool is initialized
|
|
[复制链接]
IP归属地
雷达卡
